Tally DT-230, User Manual

Page: 39 / 69

Tally Dascom DT-210/230
25
 Troubles occur during printing
Trouble Potential Problem Solution
Coloured stripe in the paper Paper near end Reinstall the roll paper
Blurred printing or spot
Incorrect roll paper installation Check if the roll paper is installed
correctly
Unqualified roll paper Use recommended thermal roll paper
Dirty thermal head or print
rooler
Clean the thermal head or print rooler
Low Print density
Increase the print density level
Paper Jam Paper stucked
Open the printer cover, check the paper
path and remove jammed paper
Vertical print words missing
Dirty thermal head or print
rooler
Clean the thermal head or print rooler
Thermal head damaged Contact your dealer for assistance
4.2 Removing Jammed Paper
Do not touch the thermal print head because it becomes very hot after printing.
 Turn the printer off and press the cover open button.

Remove jammed paper, reinstall the roll, and close the cover.

If paper is caught in the cutter and you cannot open the printer cover, open the cutter cover as
shown on the left below.
 Turn the knob until the cutter blade returns to the normal position, as shown on the right below.
There is a label to assist you.
 Close the cutter cover.

Open the printer cover and remove the jammed paper.