VOIP-200 Series IP Call Station
Configuration and Operation Manual
Page
4
of
8
Copyright 2015 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, Scream Alert, WEBS, and WEBS Contact are registered trademarks of Talk-A-Phone Co. All
rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval, endorsement,
sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
2. Getting Started
2.1. Pre-requisites
Prior to configuring a VOIP-200, ensure the unit is powered on and connected to the network.
The VOIP-200 can be configured from a computer with a TCP/IP network connection and it also supports
straight-through serial connections for basic programming. For access to the full configurable feature set, a
modern web browser will be required.
2.2. Configuration Using the Web GUI
Ensure both the VOIP-200 and your PC are connected to the Local Area Network. A direct connection to
the VOIP-200 will require the use of a crossover network cable.
VOIP-200 are pre-configured with the following default settings:
IP Address:
192.168.1.10
Username:
admin
Password:
admin@123
Configure the IP address of your PC to be on the same subnet as the VOIP-200. For example,
192.168.1.200
Open a supported web browser and direct it to the IP address of the VOIP-200. For example, enter the
The browser should prompt for authentication.
Enter the default Username and Password. After authentication is successful, you are redirected to the
Home page.
Further configuration of VOIP-200 settings are examined in Section 4: Using the Web GUI.
