The Instruction Manual
LEO 320 PROFESSIONAL shredder
Page
17
of
37
TALEX Spółka z ograniczoną odpowiedzialnością
ul. Dworcowa 9c
77-141 Borzytuchom
tel. (59) 821 13 40
e-mail:
www.talex-sj.pl
6.
Operation and maintenance
All the machine operations can be performed by the operator of the vehicle, to which the
machine is attached, providing he/she has proper authorization to operate this vehicle.
Operating the machine is permissible only after reading the instruction manual.
When commissioning and transporting the shredder, inspect its technical
condition to check for damage.
It is forbidden to stand under the raised shredder, as it may result in being
crushed by the structural elements.
When adjusting, do not place your fingers and limbs between the structural
elements of the machine.
The operator of the vehicle working with the shredder must ensure
that no person approaches the machine during its operation and adjustment, and
the distance of not less than 50m from the working shredder
is always
maintained.
When turning, reversing or manoeuvering with the machine, you must ensure,
that your visibility is adequate, or get assistance from a properly trained person.
Do not stay between the vehicle and the shredder when the vehicle engine
is running.
Working on slopes exceeding 15 is not allowed.
Exercise particular caution when working on slopes.
When making turns and returns turn off the PTO (power take-off shaft).
It is forbidden to operate the machine in close proximity of public squares (parks,
schools, etc.) or on stony grounds, to avoid the danger coming from the thrown
out stones and other objects.
Do not allow the PTO working speed to exceed 540 rpm, while driving speed must
be adjusted to the type of work being done.
Using a damaged or incomplete jointed telescopic shaft is prohibited. In
particular, it is strongly forbidden to work without covers on moving parts.
Never leave a vehicle with the engine running. Before leaving the driver's seat
(the cabin), lower the machine to the ground, turn off the engine of the vehicle,
remove the ignition key, and apply the handbrake.
Make sure that during work, fitting, dismantling or adjustment of the machine, no
parts of your work clothing are unbuttoned or hanging loose. Keep them away
from components that can catch them.
After work it is recommended to clean and wash the shredder in the wash fitted
with a sewage treatment plant or a settler to neutralize the resulting waste water.