The Instruction Manual
LEO 320 PROFESSIONAL shredder
Page
15
of
37
TALEX Spółka z ograniczoną odpowiedzialnością
ul. Dworcowa 9c
77-141 Borzytuchom
tel. (59) 821 13 40
e-mail:
www.talex-sj.pl
5.
Using the device
5.1.
Aggregating – installation of the shredder
Make sure that the connecting parts of both, the vehicle and the
machine, are suitably adjusted to each other.
In case of any doubt, always ask the vehicle or the machine manufacturer.
I.
Installation of the hitch system of the vehicle and the machine.
The machine is mounted on a three-point hitch suspension system of the tractor, vehicle.
In order to facilitate aggregating the bottom tie-rods should be located at the height of ca.
350 mm. After hitching the machine, the length of the top coupler must be adjusted in such
a way that the position of skids is parallel to the ground. The bottom tie-rod hitch chain
should be adjusted in such a way that the lateral tilts of the machine are minimal.
Depending on the three-point hitch suspension system type (TU), make sure the original
safety elements are present. Each time the shredder is mounted on the vehicle, check the
connecting elements, i.e. pins and plugs, for wear. In case of wearing out replace them
with new ones.
II.
Installation of the machine’s drive shaft.
After mounting the machine on the three-point hitch suspension system, mount the
jointed telescopic drive shaft onto the PTO of the tractor and the power input shaft of the
machine and lift the support to the upper position.
Use only the original C40210, (830 Nm, L=1100mm) jointed telescopic
shaft for the shredder drive, marked with the CE sign and PTO and
power input shaft canopies.
Check if the latches are securely clamped after sliding the jointed
telescopic shaft caps onto the PTO and power input shaft canopies.
To dismount the machine, follow the above instructions in a reverse
order, exercise particular caution when disconnecting the mechanical
system between the machine and the vehicle.