9
2. Slide an oar (a) under the bottom of the boat to raise the floor boards (b)
over the flat surface. Attach side joiners (c). Repeat the procedure on
opposite side of the boat. In case of more than one joiner on each side,
start with one long, one short joiner on one side and with one short and
one long on the other side (asymmetric).
3. Install the seat.
4. Finish inflating the air chambers one after the other in order to maintain
equal amount of air. DO NOT inflate any chamber to full capacity at the
one time. Install valve caps.
5. Inflate the keel and close valve caps.
ASSEMBLY FOR RIB-BOATS
1. When using the boat for the first time, fully inflate it by attaching the foot
pump to each of the valves, one at a time, and when pumping, ensure that a
balance of pressure between the chambers is maintained until the boat has
been fully inflated. Check the working pressure with the pressure gauge.
DISASSEMBLY
NOTE :
The boat should be clean and dry before rolling up for storage.
Remove any sand and debris
.
1. Unscrew all air valves to deflate the boat.
2. Remove the seat.
3. Remove side joiners from floor boards.
4. Raise one of the middle floor boards. Remove floor boards. Remove bow
and transom boards last.
5. Put floor boards, side joiners and oars in carrying bag.
6. Using the foot pump as a suction device, remove excess air from each
chamber.
7. With the boat now flat, tuck the tube where the oar locks are into the boat.
Roll up the boat from either end and place it in the carrying bag along with
the pump.
