7
A-Tube valve
B-Keel valve
Location of Valve
4. When using the boat for the first time, fully inflate it by attaching the foot
pump to each of the valves, one at a time, and when pumping, ensure that
a balance of pressure between the chambers is maintained until the boat
has been fully inflated. When the boat has been fully inflated, unscrew the
valves and allow approximately ½ of the air to escape. Screw the valves on
again, and continue assembling the boat.
NOTE : Do not inflate the keel until the floor boards have been installed.
5. If the boat has been previously inflated, attach foot pump to each valve,
one at a time, and add air to each chamber to ½ of their capacity.
ASSEMBLY INSTRUCTIONS FOR BOATS WITH SLATTED FLOOR
Before inflating the boat make sure that each slat is into the fabric sleeve.
The boats can then be rolled up with the slats in places. Please remove them
periodically to clean out any sand or small beach stones.
ASSEMBLY FOR BOATS WITH INFLATABLE FLOOR
