Assembly instructions
Maintenance
Version 1.0
Rotary indexer TMF
31 / 35
7.3.2
Installing the cam follower
NOTICE
Note the specified tightening torques
•
Tighten all screw connections to the specified/standardised torque
1. Heat the roll sleeve (7) to make the cam follower (8) easy to press in.
2. Press the cam follower (8) into the roll sleeve (7) up to the limit stop.
3. Allow it to cool for a short time.
4. Fit the washer (6), Schnorr lock washer (5) and hexagon head screw (4).
5. Tighten the hexagon head screw (4) to the specified torque.
6. Allow the roll sleeve (7) to cool to ensure easy assembly of the cam follower (8) in the roll start / output flange (1).
7. Press the roll sleeve (7), without canting, into the relevant hole in the roll star / output flange (1) up to the limit stop.
8. The roll sleeve (7) is held in position by fitting the retaining ring (3).
9. Press the cap plug (2) into the hole provided by approx. 0.5 mm deeper. The cap plugs (2) may not protrude beyond
the roll star / output flange (1).
10. Before the rotary indexer is put back into service, re-check the position of all cap plugs (2).
