Sprinkling Filter unit
Foaming water outlet
Rubber Gasket
O-ring
Shower head Main Unit
Surface to be Cleaned
(front and back)
Running Water
Foaming water outlet
The foaming water outlet should be rinsed with running
water in the direction shown in the illustration below:
4
Reassemble the shower head.
<Assembling Procedures>
(1) Insert the foaming water outlet and the rubber gasket in
the sprinkling filter unit in this order.
(2) Mount the sprinkling filter unit on the shower head
main unit, while the water discharge side of the
sprinkling filter unit facing down.
1
Rotate and detach the sprinkling filter unit and remove the
three parts (sprinkling filter unit, foaming water outlet,
and rubber gasket).
（※
Do not detach the O-ring.)
2
Clean the sprinkling filter unit (with water).
・
Remove dirt, such as water stain in the shower holes
on the sprinkling filter unit, with a toothbrush.
3
Clean the foaming water outlet with water.
・
Clean the unit once a month (as a general guide).
・
Remove dirt, such as water stain on the foaming water
outlet, with a toothbrush.
■
Shower head
①
②
Water Discharge Side
22
■
Neck cushion, Head pillow
At the end of work each day, wash the neck cushion and head pillow with water, wipe them dry with a
towel, and allow them to dry in the shade.If they are extremely dirty, wash with detergent diluted with water,
and rinse carefully with water. The neck cushion and head pillow are consumable supplies. Replace
them if they are extremely dirty or the surface has deteriorated.(available at an additional cost)
If chemicals drip onto the neck cushion or head pillow, rinse with water as soon as
possible. Failure to follow this instruction may cause deformation or discoloration.
Clean the neck cushion and head pillow every day. Leaving dirt uncleaned may cause
them to get moldy.
Caution
