[For PRIME TYPE (AB-HPPN) only]
2. Use needle-nose pliers to remove
the inner snap pin only.
1. Raise the chair to the maximum height and fully raise the backrest.
The legrest adjustment pin is located underneath the chair.
Changing the Raising Angle of the Legrest
Legrest adjustment pin
3
LANCER Installation Manual
Armrest control panel (left and right)
Approx. 3 seconds
▼
Electronic beep is emitted.
3
ON
3
Preset switch P1
Preset switch P2
Pull out the inner snap pin.
Inner
Outer
3. Press and hold the preset switch that you want to set, and turn on the
power switch.
Press and hold the preset switch located on either the left or right side of the armrest control panel (P1 or P2), and
turn on the power switch. Keep pressing the preset switch for approximately three seconds.
Keep pressing
until you hear an
electronic beep.
4. Setting is completed when the electronic beep is emitted.
Return the chair to its original position by using the auto-return switch, and use the preset switch to check the set
position.
Although the legrest raising angle of this chair is set to the maximum angle at delivery, you can change the angle
based on your preference.
