2. With the chair in that position, turn off the power
switch.
Although the settings positions of the preset switches are previously set when shipped from the
factory, you can change to the positions to match your customers.
Adjuster is on underside.
Extend
Retract
Tighten
Loosen
plating Flange nut (M6)
Step mount
Step (underside)
plating
Hexagonal nut (M10)
Adjuster
2
LANCER Installation Manual
Armrest control panel (left and right)
1
Power switch
1
ON
2
OFF
WARNING
CAUTION
5. Install the step.
Place the step on the step mount, align the three fixing holes with those of the step, and fix the step using the
provided
plating f
lange nut (M6). Use a wrench (No. 10) to tighten the flange nut (M6).
⇒
The adjuster, which prevents the chair from overturning, is located on the underside of the step. To adjust the
adjuster, loosen the plating hexagonal nut (M10) by using a wrench (No. 17) to adjust the height of the adjuster,
and then tighten the plating hexagonal nut (M10) by using a wrench (No. 17).
B
e sure to securely tighten the plating flange nut (M6) to install the step. Failure to do so
could result in serious injury due to the chair tipping over.
A
djust the height of the adjuster so that the adjuster does not contact or catch on the power
cord, and be sure to tighten the plating hexagonal nut (M10). Using the chair without
tightening the nut can result in damage to the adjuster.
Installation has completed. Perform the following procedures to change the position of the preset feature and
legrest raising angle.
1. Turn on the power switch and move the chair to the desired position.
*Legrest moves for the PRIME
TYPE (AB-HPPN) only.
Adjusting Preset Positions
