21
Symptom
Check this
Solution
● There is no hot water
● There is a noise when the
hot water is turned on.
●Temperature of hot water
is low.
Is the set up temperature of the water
boiler appropriate?
<Single tap type>
Is the temperature set up with the tap
appropriate?
<Double tap type>
Is the temperature set up with the
temperature control knob?
Is hair blocked in the hair catcher?
● The water doesn’t
drain well.
● Smell spoiled.
→
→
→
→
→
Is the water left in inner panel?
→
→
Before Requesting Repairs
If the following problems arise, conduct the checks outlined before requesting repairs.
Does the noise change if the taps are
turned to adjust the volume of water?
Are the water stop valves in the pipe open? Open the water stop valve
Adjust the volume of water.
(See page 11)
Adjust the set up temperature of
the water boiler to an
appropriate temperature.
Adjust the set up temperature to
an appropriate level using the
tap.
(see page 12)
Adjust the set up temperature to
an appropriate level using the
temperature control knob.
(see page 13)
Remove the hair trapped in the
hair catcher. (see page 15)
Drain the water and remove any
dust.
(see page 16)
Cleaning the dirty part.
If the product does not operate properly after checking and repairing the above points, stop using the product immediately.
Is there dirt on the basin, the inner of the
botl folder and inner panel?
After-sales Service
To request after-sales service, contact your closest dealer or Takara Belmont directly.
Disposing of This Product
When disposing of this product or replaced parts, adhere with current regulations and dispose of them
appropriately.
Summary of Contents for AY-CU-SX1
Page 26: ...26 MEMO...
Page 27: ...27 MEMO...
