37
Page
TEMPERATURE SETTINGS
-With remote controller-
Normal Operation
Owner's Guide
110 and 310 models: 100112183 (TK-RE02)
<Set temperature>
1. Turn on the 120 VAC power supply to the water heater.
2. Press the
"OPERATION"
button on the remote in order
to turn the remote controller on. It shows the set
temperature on its display as shown to the right.
3. Press the
"HOT"
button or the
"COLD"
button to set the
temperature setting of the unit.
4. You can set the temperature from 99 °F (38 °C) to 122
°F (50 °C).
Increasing temperature from 122 °F (50 °C) to 140 °F (60 °C)
•
Press the
“HOT”
button to set 122 °F (50 °C).
•
Press and hold the
“INFORMATION”
button and the
“HOT”
button for at least 3 seconds. The remote
will emit a beep and change to 131 °F (55 °C).
•
Press the
“HOT”
button to set up to 140 °F (60 °C).
Increasing temperature above 140 °F (60 °C)
•
Press the
“HOT”
button to set 140 °F (60 °C).
•
Press and hold the
“INFORMATION”
button and the
“HOT”
button for at least 3 seconds. The remote
will emit a beep and change to 158 °F (70 °C).
•
Press the
“HOT”
button to set up to 167 °F (75 °C).
“HOT” Button
“COLD”
Button
“OPERATION” Button
“INFORMATION” Button
100112183 (TK-RE02)
NORMAL OPERATION
GENERAL
1.
Open a cold water
fixture.
2.
Mix hot water with the cold water
to get the correct temperature water.
3.
When finished, close the
water fixtures.
•
Flow rate to activate the water heater: 0.5 gallon per minute at the default set
temperature (1.9 L/min).
•
Flow rate to keep the water heater running: 0.4 gallon per minute (1.5 L/min).
NOTICE
Temperatures above 125 °F (52 °C) can cause severe burns or death from scalding.
Children, disabled and the elderly are at high risk of being injured.
WARNING
°F
120
125
130
135
140
145
150
155
°C
49
52
54
57
60
63
66
68
Time to produce
serious burn
more
than 5
min.
1½ to 2
min.
about
30 sec.
about
10 sec.
less than
5 sec.
less than
3 sec.
about
1½ sec.
about
1 sec.
The temperature options
°F*
99 100 102 104 106 108 110 111 113 115 117 122 131 140 158 167
*The 100112183 (TK-RE02) can only display degrees in Fahrenheit.
