English
9
HOW TO CHARGE THE HELICOPTER
(There are 3 charging methods as shown below.)
The rechargeable battery is built in the fuselage of the helicopter. This battery should be
charged before you play with the helicopter.
Important:
Before using the helicopter the first time after purchase, charge the included battery twice in order to fully charge it. After that, if you use
the helicopter throughout the day, charge the battery only once before each use. Charge the battery twice every first time of the day
before using the helicopter.
1. Using the Eight D Alkaline Batteries
The alkaline batteries can be recharged 25 to 30 times, in normal use.
(1) Set the power switch of the helicopter to OFF and put the helicopter on the charger. Unless the power switch is set to OFF, the
charging nozzle cannot be inserted.
(2) Insert the charging plug of the charger into the helicopter charging port till it stops.
(3) Switch over the charging type selector switch to “Dx8” and press the charging start button of the charger. The red LED blinks
while charging is in progress.
(4) The helicopter will be charged completely in about 4 minutes. The red LED stops blinking and goes out, when charging is
complete. Remove the charging plug from the helicopter charging port.
2. Using the TAIYO 9.6 V Power Pack
The fully-charged TAIYO 9.6 V power pack can be recharged about 5 times. The TAIYO 9.6 V power pack / charger set is an option.
(1) Charge the TAIYO 9.6 V power pack. For the recharging method, read the instruction manual of the “TAIYO 9.6 V Power Pack
/ Charger Set”.
(2) Insert the TAIYO 9.6 V power pack into the charger socket.
(3) Perform steps
1
-(1) to
1
-(4).
(4) After recharging the TAIYO 9.6 V power pack, remove it from the charger.
(2)
Charging type selector switch
Charging start button
(3)
* Switch over the charging type selector switch to “9.6 V PACK”.
Note: If the red LED does not blink, the charging plug may not be completely inserted into the helicopter charging port. In
such case, press the charging plug into the charging port again until it stops.
(1)
(2)
(3)
Charging type selector switch
Charging start
button
HELIO_En_p02_15.p65
4/9/04, 10:01 AM
9