
English
7
HOW TO ASSEMBLE THE HELICOPTER
1. How to Install the Flap Wing
(1) As the basic installation, insert the included flap wings vertically into both sides of the fuselage as shown in the figure below.
Note: The helicopter does not turn in the right or left direction unless the flap wings are installed vertically.
2. How to Install and Remove the Antenna
* The flap wings can be installed with a 15° tilt as well as vertically. According to the selected installation angle, the balance
of right and left turning directions and the fine movement of forward/reverse travel can be adjusted.
How to install the antenna
(1) Screw the antenna clockwise into the transmitter to
install the antenna.
* The antenna is a screw-in type. A loose antenna may cause the helicopter to malfunction. Be sure to screw it in tightly.
Flap Wing
15
°
How to remove the antenna
(1) Turn the antenna counterclockwise to remove. To retract
the antenna, pull it from the lower part a little at a time.
This procedure will prevent the antenna from bending.
HELIO_En_p02_15.p65
4/9/04, 10:01 AM
7