26
TAIYO ELECTRIC IND.CO.,LTD.
26
5
Maintenance
CAUTION
The soldering unit is designed so the tip can
be replaced without turning OFF the power.
However, the tip is very hot. Do not touch the
tip or serious burns may result.
The removed tip should be placed in the tip
stand and kept there until it cools down.
1. Slide the lever on the soldering unit in
the direction of the arrow.
2. Hold the part marked A and pull the
tip out in the direction of the arrow.
The electricity to the soldering unit
automatically goes off as soon as the
lever is slid forward to remove the tip.
5-1 How to Change the Tip
NOTE )
When changing to a different type of tip, be sure to input the Tip No. (Refer to
page 11
)
Since the heater is integrated into the tip, replacement of only the heater or the tip is not possible.
A
KEY
LOCK
RX-852
HEAT
SLEEP
TEMP.
˚C
AS
4. Press any key on the keypad to start
the flow of electricity to the heater.
3. Plug the new tip into the end of the
soldering unit making sure that the
cut part on the rear end of the tip
is aligned with the cut part of the
soldering unit. Push the tip into the
handpiece as far as it will go. The tip
will not heat up until any key on the
control unit keypad is pushed.
See instruction
p. 34.
Summary of Contents for Goot RX-852AS
Page 35: ...TAIYO ELECTRIC IND CO LTD 35 ...
