Midian Encryption Programming and Service Manual
Tait Orca Portable (TOP) Encryption
41
June 2006
© Tait Electronics Limited
Fit Encryption Module
Note
Before performing these steps, ensure that the encryption mod-
ule’s flex edge connector is facing toward the TOP PCB
1.
Remove R5 and R6 on flex.
2.
Fit flexiloom firmly into module’s flex edge connector
3.
With main RF shield beside PCB as shown, fit flex into RF shield
flex edge connector
Note
There is no flex-edge connector in the Tait Orca Elan or T5010
models. If fitting to these radios, tape the flexiloom at this edge
to prevent it shorting.
4.
Gently fold the flexiloom to refit the RF shield into the chassis, then
reassemble the radio according to standard procedures.
5
1
4
1
3
2
