Tait TMAA11-06, Installation Instructions

Page: 4 / 4

4 TMAA11-06 Extended Single Head Upgrade Kit
© Tait Limited December 2016
e Use the remote U-bracket and screws provided to mount the control head. Refer to the
remote control head kit installation instructions
a
.
5 Install the cables.
a Remove the innermost connector seal from the body remote interface.
b Drill any holes required for the cables and install suitable grommets or bushings in the
holes.
c Use a neck cable to connect the
SYSTEM
socket of the radio-end extender box to the
innermost RJ45 socket of the body remote interface.
d Use crossover network cable to connect the
AUDIO
socket of the radio-end extender box
to the
AUDIO
socket of the head-end extender box.
e Use crossover network cable to connect the
DATA
socket of the radio-end extender box
to the
DATA
socket of the head-end extender box.
f Use a neck cable to connect the
SYSTEM
socket of the head-end extender box to the
SYSTEM
socket of the control-head interface box.
g Use the remote cable to connect the
HEAD 1
socket of the control-head interface box to
the rear RJ45 socket of the control head.
h Install all cable grommets. Ensure each grommet is seated correctly.
6 Connect power to the control-head interface box.
The control head, when installed over extended distances, must be powered locally using the
control-head interface box. Select from
one of the following power options:
Notice First, make sure the chosen power option is disconnected at the source.
■
Use a power cable assembly (IPN: 219-02883-00) to
connect the power connector (see right) to a power
source such as a vehicle battery (refer to the radio
installation guide), or a TMAA12 or TMAA13 power
supply.
■
Use a power adaptor rated to provide 10.8–16V DC at
>2A (IPN: 009-0001x-00, where x is 4 to 7 depending
on region) to connect the 2.5mm DC jack to a power
source.
Power can be permanently applied to the interface box without affecting current drain. The
control head will only power on when power is applied to the radio system via the radio body.
7 Check the installation.
Apply power to the control-head interface box, then the radio body. If the radio does not power
on, press the On/Off key on the control head. Check that the control head sounds the power-up
tone and the display is operating as expected.
More Information
Refer to your radio provider for more information about this product.
a. IPN 402-00020-xx, available from http://support.taitradio.com .
1 2 3 4
Pin Signal Function
1 AGND Earth return
2, 3 N/C Not used
4 +13V8BATT DC power input
(10.8V to 16.0V)