TMAA11-06 Extended Single Head Upgrade Kit
3
© Tait Limited December 2016
If upgrading a TM8200 remote installation that uses components from kit TMAA03-16, the
existing head and body remote interfaces do not support extended distances and must not be
re-used for the upgrade. For best performance the remote cable should also be replaced,
although this may be impractical for some installations. If upgrading a TM9155 remote
installation (or a TM8200 remote installation that uses components from kits TMAA03-05
or TMAA03-19), existing components may be re-used for the upgrade.
■
if the body remote interface is to be replaced, remove and discard.
d If upgrading a radio with a control head mounted locally, remove the control head from
the radio body and unplug the loom.
2 Assemble the remote interfaces.
a Assemble the body remote interface (TMAC34)
to the radio body. Ensure the earthing tag is
attached as shown.
b Assemble the control-head remote interface
(TMAA03-03) to the control head.
For more information, refer to the remote control head kit
installation instructions
a
.
3 Configure the extender box and control-head interface box links.
a Remove the seals from the top of the extender and control-head interface boxes.
b Compare the link configurations with the label diagrams. Re-configure if necessary
using small long-nose pliers (or similar).
■
One extender box must be configured as
RADIO
.
■
One extender box must be configured as
CONTROL HEAD
.
■
The control-head interface box must be configured as
LOCAL POWERED
.
c Mark the applicable diagrams on the extender box labels (for identification purposes
during the installation), and replace the seals.
4 Install the components and prepare the network cables.
a Mount or re-mount the radio body using the preferred method, such as U-bracket, slide-
in cradle, or security bracket. Refer to the relevant sections in the installation guide, or
the installation instructions included with the mounting kit.
b Prepare the crossover network cables. Before crimping the RJ45 connectors, slide on the
grommets provided for strain relief (recommended). Make sure the cabling has a direct
path and is not interrupted by network devices such as switches or routers.
Refer to the radio service manual for connector pins and signals, and schematics.
c Lay out all cables as per the diagram on
. Determine the best mounting position
for all components, at distances less than the length of each cable used.
Notice
The extender boxes and control-head interface box do not provide IP54 protection.
Choose a mounting position away from water, dust, and other environmental hazards.
d Use the washers and screws provided to mount the radio-end extender box, the head-end
extender box, and the control-head interface box.