52
System Configuration
T801-4 Installation and Operation Manual
© Tait Electronics Limited September 2007
4.2
T801-4 with Internal GPS Receiver
This configuration uses a standard product, the T801-4x-8100, which is
supplied with the Trimble Bullet III active antenna (also available separately
as Tait part number 007-00021-00).
Connection
Connect the GPS antenna to the
GPS ANT
connector on the rear panel.
Refer to
“Cabling” on page 79
for more information on connectors and
appropriate types and lengths of cables.
Link Settings
There are no changes to the factory default settings.
Programming
Program the Satsync 7 module(s) as required for:
■
output frequencies
■
output levels
■
fault output delay.
Note
Do not change the timing source options for this configuration.
Leave both check boxes clear. If two Satsync 7 modules are fitted,
set the same fault output delay for each module.
Refer to
“Setting Up the Satsync 7 Module” on page 39
for more
information on programming.
Figure 4.2
Connecting the T801-4 to a GPS antenna
Trimble Bullet III active antenna
T801-4 - rear view
