CNC-210A Series H6681 User manual
Page
10
of
20
έᚊཝҋજ̼ѣࢨ̳Φ
TAILY AUTOMATION CO.,LTD.
7.2. Station
number
Set the station number of the winding machine controller. This number is used to identify the
station when using RS-485 communication function. Up to 32 stations can be operated on the
same network. [Setting range 01~99].
7.3. Password
This password is used to protect the setting data in memory. After you set this password, you
cannot change any winding parameter and configuration data in normal sequence. You have to
key in four numbers of password before press the
,
,
,
keys. If the password has been
passed once, you can change any data in normal sequence until you turn off the power or press
key. You must to remember the password or you cannot change any data. [Setting range
0000~9999]. Set 0000 means no password.
7.4. Travel
limit
Set the maximum travel distance of guiding traverse. During winding when the guiding traverse
reaches this position, the motor stop winding immediately, and the DATA DISPLAY shows error
massage,
then RESET and go back to the READY mode. [Setting range 000.00~999.99]. 999.99
Means no limit.
7.5. Fixed
location
To set how often, must be correct the guiding traverse location. Each time when finish this
number of product pieces, the guiding traverse will moves to the home position to correct the
location before moving to starting position.
[Setting range 00~ 99]. Set 00 means not to do this function.
7.6. Limited winding speed
This value is to limited winding speed and make sure the winding spindle shaft and guiding
traverse are in synchronization. The controller uses this value to calculate with wire PITCH of
current step, and then to limited maximum winding speed of current step.
[Setting range 0~ 99999]. Set 0 means no limit speed.
7.7. Brake holding time
To set the hold times for brake. [Setting range 0.1~9.9 sec].
7.8. Guiding traverse moving speed selection
The speed at which the guiding traverse moving to the starting position and returning to the
home position. [Setting range 0~9].
7.9. Winding spindle output mode selection
Set to “
1
”
for CNC-210AS and CNC-210AE or occur a fault.
7.10. Acceleration times
Set the accelerate times for the winding spindle [Setting range 00~99].
00
means shortest acceleration times
；
99
means longest acceleration times.
T(ms)
＝（
H.S.
－
L.S.
）×【
（
N
＋
1
）×
2
】
