28
The HCL-404BKT bracket is shipped after being assembled by default, so the bracket you receive is one piece. After removing
the nut and screw at the fixed point, as well as the movable stud and buckle, the bracket is decomposed into two parts as shown
in the figure below, the left section is installed on the back of the sound column and the right section is installed on the wall using
standard screw fittings.
Tilt angle adjustment: reinstall the fixed point screw and nut, reassemble the two parts, adjust the appropriate angle, pass
the movable stud through the hole of the corresponding angle (as shown on the left below) and adjust anchor point (as
shown on the right below);
Swivel angle adjustment: remove the cover, use a tool to loosen the nut, rotate it left and right to an appropriate angle,
tighten the nut after adjustment, and reinstall the cap.
Loudspeaker-mount section Wall-mount section
4. Bracket wall mounting for HCL-404J
1) Remove the nut and screw of the fixed point of the bracket, as well as the movable studs and buckles;
2) Remove the screws on the back of the column loudspeaker, as shown in the figure below, install the loudspeaker-mount
section on the back of the column loudspeaker, and use the original screws to lock the loudspeaker-mount section and the
column loudspeaker;
3) Install the wall-mount section using the standard screws;
4) Connect the audio cable;
5) Pull up the column loudspeaker, reassemble the loudspeaker-mount section and wall-mount section, and set the required
swivel angle and tilt angle.
Summary of Contents for HCL-404
