TagMaster AB
HW Installation Guide
ELECTRICAL CONNECTIONS
Manual issue 01
18
10 ELECTRICAL
CONNECTIONS
This section describes the method of connecting the S1566 Heavy Duty Reader
WARNING
The user uses a 19-pole jackable size 14 military type connector (FCI / Souriau
part no: FCI-851 02R 14-19 P50) (Male). The instructions must be followed in order to maintain
safety for the installation crew.
Connector
The readers means of connection to the host system is via a 19-pole jackable size 14 military
type connector (FCI / Souriau part no: FCI-851 02R 14-19 S50) (Female) selected to make a
connection unexposed to dust, wet and insensitive to vibrations.
Pin configuration on S1501/03 (Female)
Power Supply Connector
PIN P DC power. (12 V)
PIN R DC power. (0 V)
DC Ground (via a “Y” capacitor and a resistor
to casing)*
•
Se Earthing requirements
RS232 communication port CAUTION is
used only for test purpose
Connector
PIN A Tx/232A.
PIN B Rx/232A.
PIN C GND/232A (internally connected to DC Power (0 V)).
The S1566 Reader host
CAUTION is used for normal operation with TRU
RS485 communication port
Connector
host PIN H
Tx+/Rx-485: Transmit (and receive when 2-wire is used), low wire.
PIN J Tx-/Rx+485: Transmit (and receive when 2-wire is used), high wire.
PIN K Gnd485: Shield ground for transmit wires. Note: Signal ground, Interface grounds are
separated from chassis.
