__________________________________________________________________________________________________________________
TAGLab
Battery Charger |
C4
Operating the Charger
•
Repeatedly press the MODE button to select the desired charging mode, 6V or 12V. The LED will
indicate your selection.
•
If an incorrect charging mode was selected, the “Error” LED will light up. In this case disconnect the
charger, wait for some time and reconnect it.
•
The charging process will start automatically. The “Charge” LED will light up throughout the
charging process.
•
The battery is fully charged when the “Full” LED lights up and the “Charge” LED goes out.
•
When the battery is fully recharged, the charger will switch to trickle charge to maintain the charging
status and protect the battery from overcharging.
Charging Time
•
Charging time mainly depends on battery condition and the battery capacity.
•
Unused battery stored for prolonged periods may be strongly sulphated or defective. Such battery may not
be recharged correctly. The charger may indicate such battery as charged. In this case the battery may no
longer be used and must be changed.
•
Battery requires regular maintenance and does not have an unlimited service life over time. This is why the
battery must be maintained by way of monthly recharges in the event of not being used for prolonged
periods.
Disconnecting the Charger
•
Completing charging and disconnecting the charger
•
Always first disconnect the power plug from the mains power socket.
•
Disconnect the black
(-)
terminal connection cable from the negative
(-)
battery terminal.
•
Disconnect the red
(+)
terminal connection cable from the positive
(+)
battery terminal.
Back-up / Power Supply
•
Under the condition of vehicle battery is taken out from engine compartment, connect positive
(+)
and
negative
(-)
clamps to power supply connection column in engine compartment correctly, and then connect
the charger to 230V / 50Hz mains power socket, the charger will supply power to car appliances (e.g. radio,
stereo) automatically.
•
"Charge" LED will light up during the power supply.
Alternator Testing
(Available in selected models only)
•
Connect the positive
(+)
and negative
(-)
clamps to the battery correctly,
