__________________________________________________________________________________________________________________
TAGLab
Battery Charger |
C4
the terminals.
•
Read the instructions of the battery manufacturer and follow the information shown in the paragraph
relating to recharging the battery in the technical documentation of the vehicle.
•
For batteries requiring maintenance, it is of prime importance to check the level of electrolyte before
charging and top up the level if required. Leave the caps removed during recharging. Use distilled water.
Sealed batteries or not requiring maintenance do not have removable caps and do not require any
maintenance.
Connecting the Charger
•
Connect the required terminal connection cable (with rings or clamps) to the quick plug connection (3).
•
Connect the red
(+)
terminal connector cable to the positive
(+)
terminal of the battery.
•
Connect the black
(-)
terminal connector cable to the negative
(-)
terminal of the battery.
•
The black
(-)
clamp can also be connected to the vehicle body however away from the fuel pipes. (Please
refer to the vehicle manufacturer’s instructions). Be sure both clamps have good contact and are firmly fixed.
•
Connect the charger plug into a 230V / 50Hz mains power socket.
•
If the charger is connected correctly, the “Power” LED (12) will light up. In this mode the charger will
automatically reset to the default settings.
•
If the battery is recognised to be defective or connected with the poles reversed, the “Error” LED (9) will light
up. In this case, disconnect the charger and check the battery and the correct connection (also see
“Troubleshooting”).
