Operation
1. Plug the Power Cable to the subwoofer and into the electrical outlet.
2. Turn on the subwoofer – press the Power Switch to the ON position.
The Power Status LED Indicator should be illuminated in a few seconds.
If it does not, it means that the subwoofer is working under in abnormal condition (a protection mode)
- turn off the power, unplug the Power Cable and check whether some of the cables are not short
circuited.
After fixing the cables turn the subwoofer on.
Note!
Check “Additional Information” for other useful operating instructions.
High volume levels may damage this subwoofer. This may void your warranty.
VOLUME Regulator:
Using the Volume Regulator on the rear panel you can adjust the sound volume from minimum
(the knob – max counterclockwise) to maximum (the knob – max clockwise).
Distortion and sound quality worsening may occur when the knob
is in the maximum position. It may damage the subwoofer.
This may void your warranty.
Operation Mode Switch:
The subwoofer is
equipped with the auto audio signal detection feature.
When the subwoofer is turned on choose one of the three operating modes:
ON – when the Power Switch is in the ON position, the subwoofer will remain continuously turned on.
Auto Power – when the Power Switch is in the ON position:
• If no input audio signal is detected for a certain period of time the subwoofer will go into the standby
mode.
• If the subwoofer receives the input audio signal it will automatically go out of the standby mode
and will start working.
OFF - the sound output is muted. The subwoofer remains turned on.
If the input audio signal is too weak, the Auto Power mode may not operate
properly - try to increase the subwoofer output level in your audio equipment
settings or use the ON mode.
The time necessary to turn on and off the Auto Power mode may vary on the
input audio signal strength and the time of the subwoofer’s activity.
11
Status
Power Status LED Indicator
ON
(green)
AUTO POWER
(green) signal detected
(red) no signal
OFF
(red) output muted
