Taga Harmony HTR-1000CD v.3, Instruction Manual

Page: 18 / 40

Operation
ECO-Power/Standby and Automatic Standby features
Switching ON / OFF
When you connect the CD-Receiver to the electrical outlet for the first time and when
switched on after a power failure, it will be in the Standby mode - [----:----] will be displayed.
• Press the
Standby
or select any input on the remote controller to switch the
CD-Receiver on.
[TAGA HARMONY] will be displayed.
• [PREHEAT] will be displayed and a countdown of 10 seconds will start for preheating
of the CD-Receiver.
Then, the CD-Receiver will switch to the last selected input.
• Press the Standby button to switch the CD-Receiver back to the Standby mode.
[BYE BYE] will be displayed.
Switching the CD-Receiver to ECO Power/Standby mode
When the CD-Receiver is in one of the Standby modes (ECO Power or Normal) press and
hold the Standby button for 2 seconds or more to switch between these modes.
• ECO Power Standby mode
After activating this mode, [ECO POWER] will be displayed and the ECO Power Standby
Mode Indicator will be illuminated.
Then the Display will be turned off. The Clock will not be displayed.
Press the CLOCK button - the CD-Receiver will activate the Normal Standby mode and the
Clock (if set) will be displayed for some time.
• Normal Standby mode
After activating this mode, the ECO Power Standby Mode Indicator is not illuminated and
the following will be displayed: [----:----] - if the Clock is not set.
Time [hour:minute] - if the Clock is set.
After some time, the Display will be turned off and the CD-Receiver will automatically switch
to the ECO Power Standby mode.
Note! The power consumption in the Normal Standby mode is higher than in the ECO
Power Standby mode – check “Specifications” for more details.
Note! When switched off, the CD-Receiver will go to the Standby mode that was activated
before switching on.
Your CD-Receiver is ready for operation.
Note! Check “Additional Information” for other useful operating instructions.
Display
In relation to the CD-Receiver features and operation, unless said otherwise, the square
brackets [ ] indicate that the information they contain will be displayed on the Display.
17
Connecting to the Electrical Outlet
Plug the Power Cable to the CD-Receiver and
into the electrical outlet.