ILLICO User’s Manual
7
6
ILLICO User’s Manual
OPTIONS ILLICO
OPTIONS ILLICO
WIRELESS SYSTEM VHF OR UHF
The cabinet can be equipped with one wireless system. It can be chosen between a VHF single fre-
quency receiver (non diversity), a UHF 16 frequency receiver (non diversity) and a UHF 16 fre-
quency receiver (true diversity).
Technical caracteristics of receiver R-300M
VHF receiver, Non Diversity
3
Volume button:
Seperate volume control for the wireless system.
3
Switch on the handheld microphone/beltpack transmitter:
The LED is lightning when the VHF link between transmitter and receiver is ok.
Technical caracteristics of receiver SDR-500M
UHF receiver, True Diversity, with Pilotone.
3
Volume button:
Seperate volume control for the wireless system.
3
Switch on the handheld microphone/beltpack transmitter:
The LED is lightning when the UHF link between transmitter and receiver is
ok. Channel can be changed with the switch located near the volume control.
RECEIVER SDR-6216M
Technical caracteristics of receiver SDR-6216M
UHF receiver, True Diversity, with Pilotone.
3
Switch on the receiver:
The switch on the right is power switch and volume control
3
Switch on the handheld microphone/beltpack transmitter:
The LEDS A and B are lightning when the UHF link between transmitter and receiver is ok.
Channel can be changed with the switch on the left side.
On/Off + Volume
Selection of the channel
LED A et B
VHF OR UHF HANDHELD MICROPHONE TRANSMITTER
Corresponding to the wireless system the Microphone has to be a VHF or UHF Microphone
Transmitter.
HANDHELD MICROPHONE TRANSMITTER Q-1002 (VHF)
The microphone is equipped with 1 frequency
1. Microphone capsule
2. Battery status - LED indicator
3. Battery compartment
4.Power switch (ON/OFF)
Battery Installation
Q-1002 uses 1 piece of 9V battery. To install new or replace the old battery, First unscrew the
battery cap from the battery compartment, then insert the new battery according to its correct
polarity as indicated. For longer operation hour, Alkaline battery is recommended!
After putting the battery cover back to the housing , slide the switch to "ON" position as shown
below.
As soon as the power is on, the battery-status indicator will give flash, indicating a normal opera-
tion. If there is no flash, it indicates either power supply is not available or battery is
installed wrongly.
After switching on, the therefore signal indicator LED(s) of matching receiver will light up, indica-
ting the microphone signal transmission is in normal operation.
Switch off the power when the microphone is not in use, meanwhile, remove the battery out of
microphone if it is not to be used for an extended period.
slide to “ON”
position
For longer operation hour, Alkaline battery is recommended! Wrong batteries can
damage the microphone functions. Check battery status. Many batteries are known
to have leakage problem of conductive and corrosive liquid. Remove the batteries if
you do not plan to use the microphone for a few days.
L
L
CAUTION: BATTERY
2
1
3
4
