4
ILLICO User’s Manual
BATTERY
ILLICO is equipped with a lead 9Ah / 12V lead battery making lots of loadings and unloadings
possible. When connected on AC main the sound system can work without time limit, while char-
ging. Minimum autonomy: 3 hours, maximum: 6 hours.
It is a battery drawer allowing quick and easy replacement if necessary. To do so, unlock the two
screws and disconnect the two power threads while respecting the polarity.
CONTROL LEDS
3
GREEN LED "ON":
- The equipment is ready to work
- The battery is loaded
3
RED LED "UNLOADED BATTERY":
- Battery has reached its time limit. Estimated working time left: from 5 and 20 minutes depen-
ding on working options
- If you have to use the equipment longer than the estimated time connect on AC main. No
working time limit, the battery is loading simultaneously.
3
ORANGE LED "CHARGER":
- ILLICO under power, switch “ ON ”
- The internal automatic charger will increase battery tension up to its highest level +/- 13 V.
POWER SUPPLY INPUT
12 Volts power supply input. Allows working on AC main and battery loading of ILLICO.
It is recommended to use the provided cable for recharge.
NEVER STOCK THE EQUIPMENT WITHOUT HAVING RELOADED IT. It is recom-
mended to switch of the equipment while loading to ensure a full battery recharge.
L
L
CAUTION: BATTERY LOADING
ILLICO User’s Manual
5
BASIC EQUIPMENT
BASIC EQUIPMENT
2 MIC OR/AND LINE MIXABLE INPUTS
ILLICO is equipped with 1 balanced MIC control input on Jack 6,35 and 1
RCA Line control input.. The input selection is automatic. If both inputs are
connected, you can use them simultaneously
TONE ADJUSTMENTS
The ILLICO is equipped with 3 highly performing tone adjustments.
1 bass frequency tone control on 100 Hz with +/- 12 dB efficiency.
1 treble frequency tone control on 10000 Hz with +/- 12 dB efficiency.
1 voice adjustment especially designed for use in medium frequency which allows for a
sharp increase of voice presence on the mic inputs.
LINE OUTPUT
The ILLICO is equipped with 1 RCA line output enabling connection to another ILLICO
or to any other sound system. You just have to connect the ILLICO Line out to the Line In
of the selected equipment.
SPEAK OUTPUT
ILLICO is equipped with an amplified jack output (diameter: 6,35) for potential use with
another passive speaker, ref: SP-265, signal cable: CH15.
NEVER CONNECT a 4 OHMS SPEAKER: THIS COULD DAMAGE THE ILLICO’S AMPLIFIER.
Jack cabling: you MUST use mono jack, + on the TIP, - on the RING.
To avoid the larsen effect when you switch on mics, do not turn the gain if you are not
far from ILLICO. ADVICE : We strongly recommend that you switch off the mic,
adjust the volume of the ILLICO to the desired volume, then be a few meters away
before switching on the mic again.
L
L
CAUTION : MIC Adjustment
