MANUFACTURING INSTRUCTIONS
MI-10459T Rev01
DAB fitting
Manufacturing Instructions:
Team Affected
CELL
Y:\design\Manufacturing Instructions\AVP MIs\MI-10459T Rev01.wpd
.
Page 3 of 5
15
Fit support pillars
Hold Dual Sharc card in position with the 3
remaining pillars supplied.
20
Attach pink/black cable
Plug DAB assembly into the headers on the
Dual Sharc card, take care to ensure they are
aligned - do not force the board down.
Plug the pink and black wires header into the
two pin connector on the DAB card. The
connector should be with black wire towards
the rear of the unit. Secure the DAB card with
the screws and washers removed earlier from
the Dual Sharc card plus the extra supplied in
the kit.
25
Remove blanking grommets
Remove the blanking grommet from the rear
panel where the DAB aerial connector is fitted.
