MANUFACTURING INSTRUCTIONS
MI-10459T Rev01
DAB fitting
Manufacturing Instructions:
Team Affected
CELL
Y:\design\Manufacturing Instructions\AVP MIs\MI-10459T Rev01.wpd
.
Page 2 of 5
Tools required - not supplied
Tool
Description
1
T10 Torx driver (for M3 Torx screws)
2
T20 Torx driver (for M4 Torx screws)
3
5.5mm A/F socket/nut spinner (for M3 nuts and spacers)
4
16mm A/F socket/nut spinner (for DAB aerial cable connector)
Assembly Instructions
0
Remove cover
Place the AV192R on a clean bench with the rear facing you. Remove the 5 M3 Torx screws that
retain the cover on the rear. Remove the M4 countersunk Torx screw from each side of the cover.
Grip the sides of the cover at the rear and prise out slightly. Slide the cover back about 5mm to
free the front edge from under the fascia and then remove the cover.
5
Pillar for Dual Sharc card
Pillar supplied in kit - needs to be mounted on
the Dual Sharc card.
Pillar mounted on component side, washer
and nut on underside.
10
Remove Dual Sharc card
Dual Sharc card is held in position with 3 M3
Torx screws. Note that there is one large
mounting hole vacant.
Remove the 3 M3 Torx screws holding the
Dual Sharc card in position. Carefully
withdraw the Dual Sharc card from the
headers on the chassis board.
Fit the pillar in the vacant mounting hole
noted above as indicated on the left.
Refit the card taking care to align the headers,
do not force into position - do not fit the
screws.
