TAG
Heuer Timing
Page 20 / 49
The sequence has to be respected.
-
Start Count Down: (Input 3). If the countdown = 0, it will validate the competitor (from Next competitor to
Competitor on Run)
-
From this point, each impulse on Input 1 will be displayed on the LCD and printed. You have 5 sec to
validate this time.
o
If the time is not validated, you will be able to see it again on the function Recall (“
R
”)
o
If you validate the time, it is used for the next calculation.
-
From this point, you are allowed to add points, remove points, and validate the next impulse on Input 4.
8.4. Mode: Jumping 2 Phase / Jumping SNG Phase
The sequence for this mode is similar as the Jumping mode
The normal sequence for this Timing Mode is
-
Start Count Down (Input 3) : will start the session for a new competitor
-
Start Race (Input 1)
-
Jump-off (Input 2)
-
Finish Race (Input 4).
The sequence has to be respected.
-
Start Count Down: (Input 3). If the count down = 0, it will validate the competitor (from Next competitor
to Competitor on Run)
-
From this point, each impulse on Input 1 will be displayed on the LCD and printed. You have 5 sec to
validate this time.
o
If the time is not validated, you will be able to see it again on the function Recall (“R”)
o
If you validate the time, it is used for the next calculation.
-
From this point, you are allowed to add points, remove points and validate the next impulse on Input 2
(Jump-Off)
-
In Timing Mode: Jumping 2 Phase: you have two possibilities:
o
The competitor received points penalties: in this case, the software will not authorize you to go
further, and the ranking will be calculated.
o
The competitor received no points penalties: the software will restart automatically the start to
count up for the Phase 2, until Impulse on Input 4 is validated.
-
In Timing Mode: Jumping SNG Phase:
o
The competitor continues the second phase automatically irrespective of any time faults /
penalties accrued in Phase 1.
Do not close the run until you are sure that all data (penalties) are correct.
Once the Run is closed, you cannot make any further corrections.
8.5. Points
penalties:
You can introduce points penalties during a competitor’s run, by entering the value of points (eg: 4) and
validating by pressing Enter (
◄┘
)
Remove points penalties
:
To remove points penalties during a competitor’s run, you have to press “
”and number of points you want
to remove, validating by pressing Enter (
◄┘
)
---- ---- 10 :45 :26 ---- ----
10 <
Time Ref
85
Point
0
Pause Penalty 0
Time Penalty
0.00
10:46:32.23
10
2.36
Locking Input
Time to validate
Running time
Next competitor
Competitor on run
