TImING USING THE «FLYBACk» FUNCTION*
With the "Flyback" function you can make rapid successive time measurements with a single press
on button
B
, without needing to stop and reset the counters before restarting the chronograph.
Note
: since this function does not stop the chronograph before restarting a new measurement, the
result can only be read on the go. So you are advised to observe the measured time properly before
pressing the flyback button
B
.
1. Press button
A
to start the first time measurement.
2. Press button
B
: the chronograph will restart immediately for a second time measurement.
3. Press button
B
again for each consecutive time measurement.
4. Press button
A
to stop the chronograph; the elapsed time of the latest measurement will be
indicated by the counter hands
5
,
6
and
7
*.
5. Press button
B
to reset the counters.
*According to model
FIxED BEzEL WITH TACHYmETER SCALE*
You can use the tachymeter scale in combination with your chronograph to determine your average
speed over a given distance of 1 km or 1 mile, for a speed of more than 60 km/h or 60 miles/h, or for
a travel time of under 60 seconds.
To determine your average speed, start the chronograph at the start point, and stop it at the end point
of a 1 km or 1 mile trip stage. The numeral on the tachymeter scale to which the seconds counter hand
5
is pointing corresponds to the average speed of travel in km/h or miles/h.
*According to model