Taewoo cuTex TBC-50SH, Manual

Page: 25 / 26

E-mail : taewoo@cutex.kr http://www.cutex.kr
- 24 -
Trouble-shooting of TBC-50 series
No Troubles Appicable model Causes & Measures
1 No power supply All models
- Check if electric cord is connected well.
- Check if the fuse blows out or not.
2
Power is on,
but no work
Feeding roller
doesn't work.
All models
- Check if there is inserted any alien
substance in roller.
- If current length on display is changed,
exchange drive board.
- If current length on display is not changed,
exchange Control board(MB).
Knife doesn't
work.
All models
- Check if pressure plates of upper knife are
too much fastened or not.
LCD display
doesn't work.
All models
- After opening the cover, check the connetion.
(especially between Operation & MB board)
All functions
don't work
Al models
- Check if auto-stop device lies down. If any,
raise it up.
3 Material is not cut.
Hot cutter
(H, LH, SH, HX)
- Check if temperature goes up to set-degree.
- Check if knife blades are even(parallel).
4 Material is cut onesidedly. All models
- Check if blades are damaged or weared.
- After making both knives close each other
by M/CUT button and check if they are even
or not. (If they are not even, adjust them by
bolts)
5
Cut-length is different from
set-length.
All models
- Test cutting after loosening material from the
reel by hand or attaching feeding device.
6
It cuts before the cutting line
of labels. Label cutter
(S, SH)
- Move the sensor towards knife side as long
as the difference by pushing.
7
It cuts after the cutting line
of labels. Label cutter
(S, SH)
- Move the sensor towards counter-knife side
as long as the difference by pushing.
8
ERROR
on LCD
& LED
ERROR CODE [064]
>Sensor check Er
Label cutter
(S, SH)
- Trouble in Mark sensor
→
Check if the sensor is connected well or not.
Check if the sensor is adjusted well or not.
(FILE NO 001)
Check if it is label problem or not.
ERROR CODE [065]
>CUT I/O Error!
All models
- Trouble in cutting motor or cutting sensor
→
Upper knife moves 1~3 sec. and ERROR
on display. Check the connection of cutting
sensor. If not, exchange the cutting sensor.
Upper knife doesn't move and ERROR on
display. Exchange the cutting motor or drive
board.
STOP INPUT !!
CHECK STOP INP!
All models
- Auto stop device is pressed down or shortage.
→
raise up the device and check shortage.
(C)ACORD CTRL-OP
AMC-T3KA VER1.7D
All models
- Bad connected ROM
→
Press ROM by hand
or connect it again. (If not, change MB board)
ERROR CODE[065]
>CHECK CODE[003]
All models
- Change of FILE 003 in program by noise or
mis-operation
→
Initialize the controller .
※
How to Initialize(programs to be initial) :
press SET
＋
SHIFT/ESC buttons and
RESET button at the same time.
(Press RESET later than other two keys.)
9
Operator feels electric current
in touch of machine.
All models
- Connect the earth cord(green) to any bolt of
backside of machine.
10
After exchange ROM, you should do initialize the controller , due to error message,
if you cannot do initialization, please press "SHIFT/ESC' button to escape error message screen
and then
initialize the controller.