PCP-1500/2000
A
/
2000/
5000 Series
Rev 3
2023/01/16
50/52
Copyright © 2023 by TAEHA CORP. All Rights Reserved
7.1
Alarm display and action
The Pro-Pump System informs the user of the occurrence of alarms in the following ways wen errors
occur.
Front Touch Panel
System status I/O contact point output
The related alarm codes can be checked through the front touch panel, where each alarm code is
displayed..
Classification of abnormal phenomena is as follows.
Alarms that may occur due to hardware protection or internal element breakage
Alarms that may occur from incorrect settings when setting motion programs and points
Alarms that may occur due to other mishandling, etc.
If an alarm occurs in the hardware protection system during operation, the output to the motor is cut
off and the servo is turned off. In order to restart operation, it is necessary to remove the cause of
alarm and then release it for normal operation..
Caution
Some alarms cannot be released even after reset. In this case, you must
reboot(power ON/OFF) after completing action for the relevant error.
