LIGHT BULB REPLACEMENT
ght fixture.
f the light
5.
ckwise to release light from fixture.
6.
7. Rep
8. Rep
t compartment door.
9.
Note: F
ed T
n front of the Ozone Sterilizer (optional) is the indicator light. To verify that the Ozone Sterilizer is
p is running. The Ozone Sterilizer will shut
sed.
while the filter pump is
nning, follow these steps:
. Disconnect electrical power supply.
. Locate and unplug the Ozone Sterilizer from the control
center.
. Disconnect the output tubing from the Ozone Sterilizer.
. Remove the mounting screws that hold the Ozone
Sterilizer in place.
.
Take the entire Ozone Sterilizer to your authorized
Tadpole Hot Tub dealer. The unit will be check to verify
that it is defective. If not, request a service call.
.
Reinstall the Ozone Sterilizer by reverse the above
procedure.
To replace a burned out or defective light bulb, complete the
following:
1. Disconnect electrical power supply.
2. Remove equipment compartment door.
3. Locate the back of the li
4. Grasp the light bulb holder (located on the back o
fixture).
Twist counter-clo
Pull light bulb holder out of the fixture.
lace light bulb and reinstall light fixture.
lace equipmen
Restore electrical power supply.
or alternate lighting systems, contact your authoriz
adpole Hot Tub dealer.
OZONE STERILIZER REPLACEMENT
O
working properly, check the indicator light while the filter pum
down for 30 minutes after the JETS button has been pres
f the indicator light does not glow
I
ru
1
2
3
4
5
6
Tadpole Hot Tub Owner’s Manual
22
