Tador KX-T918-AVL, Instruction Manual, Page: 3 / 20

3
4.
Set lock type
Connect Jumper JM1 according to type of lock you are
Using. (See picture)
Jumper
JM1 is placed on the right side at the bottom
of the Electric board
Jumper mode lock type
Jumper on two left pins Electric lock (Normally open)
Jumper on two right pins Magnetic lock (Normally close)
5.
Before Installation
Install the lockand prepare the wires infrastructure:
Two wires from the power supply, two wires to the lock, two wires to the PBX extension
and another two wires for Push to exit button(if installed).
Assemble the wires through the hole on the back box of Tador Codephone.
Mark the four drill points of the back box on the wall. Drill and install the back box to the
wall.
Make sure the AC adapter is unplugged.
Connect the wires to the Electronic circuit using the captions on the PCB and using the
electric diagram (refer to page 10)