14
6.
Talk time
–
This programming sequence sets the maximum time allowed for
conversation from the time the
Tador Codephone
places the call(default 60 seconds).
Example:
changethe talk time to 90 seconds.
Enter remote programming mode, enter cell number 90, followed bythe new time
that you want to set 90(two digits), and then press Hash (#) key to approve.
7.
Number of Rings to Answer
–
This programming section sets the
number of rings that the
Tador Codephone
will allow to pass through the system before
it picks up the call. Cell number 12, (default one ring).
Example:
Change the number of ring to answer to 3 rings.
Enter remote programming mode, Enter cell number 12, followed bythe new
amount of rings you want to set 03(two digits), and then press Hash(#) key to
approve.
8.
Camera relay strike
–
Set the camera relay strike time (play time, default
30 sec).
Example:
changethe camera uptime to 40 seconds.
Enter remote programming mode, Enter cell number 14, followed bythe new value
you want to set 40(two digits), and then press Hash(#) key to approve.
•
See last page for camera connection diagram
9.
Door opening delay
This is a time that passing after entering access code or coupling RFID card to actually
lock activation (in standard situation no need to change).
Usually using when panel located far away from the door. The data located in memory
cell 01.
Example: Set delay time 3seconds
Exit Programming mode
Approval
New time
Cell number
programming
Programming code
##(Hash)
#
90
90
##
Call Codephone
Exit Programming mode
Approval
New value
Cell number
programming
Programming code
##(Hash)
#
03
12
##
Call Codephone
Exit Programming mode
Approval
New value
Cell number
programming
Programming code
##(Hash)
#
40
14
##
Call Codephone
Exit Programming mode
Approval
New value
Cell number
programming
Programming code
##(Hash)
#
03
01
##
Call Doorphone
