9
TAD-R1TX
English
Removing The Grille Covers
The bass drivers come equipped with grille covers that should
be removed when the loudspeaker are in use (see Figure 6). To
remove them, grasp each grille along the edges, pull it out, and
store it in a safe place in case of future use when moving or
storing this unit.
Figure 6. Removing the grille from the
TAD Reference One loudspeaker
Installing The Spikes
WARNING!
Be sure to use two people when installing the spikes. Be
careful to not pinch your fingers under the loudspeaker and
make sure the loudspeaker does not fall on its side.
Caution
Please be sure to screw all the way in when installing spikes.
The installation of spikes on the bottom of the unit allows you
to establish a firm connection between the ground and the
loudspeaker when placing the loudspeaker on uneven surfaces.
The bottom of the cabinet features three areas for these spikes.
The use of three spikes for support eliminates the need for fine
adjustments, allowing you to keep the loudspeaker firmly in place.
See Choosing Where To Place The Loudspeakers on page 10 for
help deciding where to place the loudspeaker, and Figure 5 for
how to install the spikes.
There are screw holes on the aluminum plates located on the
bottom of the cabinets.
Please be sure to screw all the way in when installing spikes.
Figure 5. Installing the spikes
Summary of Contents for Reference One
Page 1: ...TAD Reference One...
