12
CAUTION
'
When connecting speakers or other components, always turn off the power to the amplifier, and disconnect the power cord.
'
Speaker cables are not furnished with this speaker system, and must be purchased separately.
'
After connecting the speakers, gently pull on the speaker cables to confirm that each cable wire is connected securely to its
respective terminal. Loose connections may result in interrupted sound or noise.
'
Do not allow wires from one connector or cable to touch those from another, since excessive load may be applied to the
amplifier, causing the amplifier to stop operating or be damaged.
'
If the polarity (+/
−
) of either right or left speaker is mistakenly reversed when connected to the amplifier, the speakers will
be unable to produce proper stereo phase effect.
Single-Wire Connections
For single-wire connections, connect the high- and low-frequency sections of the crossover network with the shorting link that was included
with this unit, then connect the (+) wire from your amplifier to either red binding post and the (–) wire from your amplifier to either black
binding post, as shown in Figure 8.
CONNECTING THE SPEAKERS
HF
Figure 8. Connecting a TAD Reference One
loudspeaker in a single-wired system.
TAD Reference One
Terminal Panel
Amplifier
(rear)
(one channel shown)
Shorting links
SPEAKERS OUTPUT
Summary of Contents for Reference One
Page 1: ...TAD Reference One...
