TAD DA1000, Owner'S Manual

Page: 15 / 128

15
English
SPECIAL SETTINGS
Changing the TAD-DA1000 input mode
 Press the INPUT button on the m ain unit’s front-panel (or one of the INPUT buttons on the re m ote control unit).
Each time the front-panel INPUT button is pressed, the input mode will change in the following order :
D1 (XLR) U1 or U2 (USB input) D2 (coaxial)
D3 (coaxial) D4 (optical)
 In the factory default condition, when an input signal is detected, the signal
’
s sampling rate will be displayed. When no
input signal is detected, the display will show [ - - - ] .
 The sampling rate display is in units of kHz
;
fractional decimal points are omitted.
 In the case of DSD signals, [ dSd ] is displayed for
2
.
8
MHz modulation, and [ dSd2 ] is displayed for
5
.
6
MHz modulation.
 When the display mode is changed, if an input signal is detected, the display will show
[ U1 ] ;
if no input signal is
detected, the display will show [ U1- - ] .
Adjusting the sound volume
Adjusting the balanced/unbalanced line output level
In the factory default condition, the line output VOL (−/+) buttons and the remote control ’ s center VOLUME (+/−) buttons are
disabled. The volume output is factory preset at 78 ( m axi m u m value) .
 Press and hold the m ain unit’s VOL (−) button.
The main unit
’
s
VOL (−/+)
buttons and the remote control
’
s center
VOLUME (+/−)
buttons will be enabled. In addition,
the display will switch from showing the sampling rate to the line output volume.
When the main unit
’
s
VOL (−/+)
buttons and the remote control
’
s center
VOLUME (+/−)
buttons are enabled, the
initial default output value will be 30 .
Note
 When using the volume function and connecting directly to a power amplifier (without using a pre-amplifier), be sure to
make the connection only after setting the volume to “0” (zero) . If the connection is made with the volume set to its default
value (maximum), the speakers could be damaged.
Adjusting the headphones volume
 Press the volu m e (−/+) buttons located beside the headphones jack, or the volu m e (+/−) buttons under the headphones
sy m bol on the re m ote control unit.
The default value is preset at 50 . This value can be ad
j
usted independently of the balanced
/
unbalanced line output
values.
To fix the line output levels at their maximum
1. Press the m ain unit’s VOL (+) button (at the left of the display) until the display indicates the m axi m u m value of 78.
2. With the value set to its m axi m u m , press and hold the VOL (+) button.
The line output level will be fixed at the maximum value, and the main unit
’
s
VOL (−/+)
buttons and the remote
control
’
s center VOLUME (+/−) buttons will be disabled. When this is done, the display will change from showing the
line output volume to showing the sampling rate.
Changing the display mode
 Press the DISP button on either the m ain unit or the re m ote control unit.
Each time the button is pressed, the display mode will change in the following order
:
When line output value is fixed
When line output value is adjustable
Line output volume (example: [ U1 L 50 ]) Headphones output volume (example: [ U1 H 50 ])
Sampling rate (example: [ U1 44 ]) Display OFF
Sampling rate (default value: sound volume fixed) (example: [ U1 44 ])
Headphones output volume (example: [ U1 H 50 ]) Display OFF