TAD C600, Owner'S Manual

Page: 17 / 116

English
17
TAD-C600
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this
component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components
and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your
dealer.
Symptom Possible cause Remedy
No sound even when
source is selected.
• The input connectors are improperly connected.
• The MUTE function is enabled (“- - - -” appears
flashing in the display).
• Sound volume is set too low.
• The connectors to the power amplifier have not
been selected in the output settings menu.
• Check connections.
• Press the MUTE button on the main unit or the
remote control to disable the MUTE function.
• Adjust the sound volume properly.
• In the output settings menu, select the connectors
on the main unit connected to the power amplifier
(page 15).
Noise is heard even when
no input is selected.
• Noise is present in the power source itself. • Confirm that no other digital appliance is
connected to the same power outlet.
Power doesn’t turn off. • A signal is being input to the SLAVE IN jack. • Turn power OFF at the MASTER device.
Power turns off by itself. • If the auto power down function is set to ON, the
unit will automatically switch to Standby after
three hours of inactivity.
• Set auto power down function to OFF (page 14).
Can’t see display. • The display is set to OFF. • Press the DISP button to cancel display OFF.
Can’t be remote
controlled.
• The remote control’s batteries are depleted.
• Distance is too far. Angle to the signal sensor is
too extreme.
• An object is interrupting the signal path.
• A strong fluorescent or other light is directed
toward the signal sensor.
• Replace batteries with new ones.
• Be sure to operate within 7 m and a 30° angle of
the remote sensor on the front panel.
• Check that there are no obstacles between the
receiver and the remote control.
• Make sure that there is no fluorescent or other
strong light shining on to the remote sensor.
TROUBLESHOOTING