6
SPRAY BUFFING
Use 3/4” to 1” thick HOG HAIR high speed burnishing pad. The spray buff solution should be
applied to the floor ahead of the machine. Do not run the machine into the spray or mist of the
spray buff solution.
DAMP BUFFING
Use 3/4” to 1” thick BEIGE high speed burnishing pad. Use a well-wrung out mop to apply damp
buffing solution. Go over dampened surface with machine until surface is dry and has a high
glaze.
STORING
Store with pad off the floor by tilting machine back on the support wheels.
BELT MAINTENANCE
(WARNING: REMOVE LP TANK BEFORE TURNING OVER THE MACHINE)
To change a broken or worn belt, turn the machine on its side and remove the pad and pad driver.
Using a wrench, loosen the hex bolt for the pulley tensioner. Once the tensioner is loose, the belt
can be easily removed. Slip the old belt off the pulleys and reattach the new belt. Attach the
pulley tensioner back into position and retighten its bolt. The tensioner should provide the belt
with a 0.16 inch belt deflection when a force of 2 pounds is applied against outside of belt. Turn
machine upright immediately after service is completed.
Maintenance Table:
These are typical service intervals. Service more frequently under more severe operating
conditions.
Type of Service
Daily First 8
Hrs.
Every
25 Hrs.
Every
50 Hrs.
Every
100 Hrs.
Every
200 Hrs.
Every
300 Hrs.
Every
500 Hrs.
Check Oil for Proper Fill Level
++
Check Bonnet Air Filter for Obstruction
•
Check Cleaning Pad for Wear
•
Check Drive Belt Tension
•
Inspect for Loose Bolts & Connections
•
Change Engine Oil ++
•
•
Clean Air Cleaner Foam Element
•
Clean Air Cleaner Paper Element
•
Tighten Nuts, Screws, & Brackets
•
Clean and Adjust or Replace Spark Plug
•
Clean Engine Cooling Fins
•
Change Oil Filter
•
Replace Air Cleaner Paper Element
•
Adjust Engine Valve Clearance
KD
Clean and Lap Valve Seats
KD
Clean Cylinder Heads of Deposits
KD
Recertify Emission Control System
^^
