5
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
DRY OPERATION OF VACUUM (1-3)
The wet/dry vacuums are equipped with a bypass motor. Install the filter frame and
cloth filter, place the motor head on the canister and snap down the hold-down clamps.
WET OPERATION OF VACUUM (1-3)
The wet/dry vacuums are equipped with a bypass motor
so that the working vacuum is separated from the cooling
air flow. To pick up water, the dry filter must be removed
and the float cage assembly must be in place, the motor
head placed on the canister and the hold down clamps
locked down. The safety float located in the protective wire
frame in the tank stops the vacuum action of the motor
head when the maximum recovery of liquids is reached.
WAND AND ATTACHMENT INSTRUCTIONS
To assemble the two piece wand:
1. Match the alignment ridges of the upper and lower wand sections.
2. Push the upper wand into the lower wand.
To assemble tools:
1. Slide the swivel cuff of the tool onto the tapered lower wand.
2. Turn swivel cuff 1/4 turn to tighten.
PUSH HANDLE
The cleaner is shipped with the upper handle disconnected.
To convert to operating position:
1. Turn knobs on tip dolly counter clockwise until clear of tubing material.
2. Slide upper handle into lower tubing of the tip dolly.
3. Turn knob on tip dolly clockwise until snug.
DRAINING (1-4)
1. Disengage the two (2) clamps which hold the motor head to the canister.
2. Remove motor head and carefully place to one side.
3. Tip can over by grasping handle, lift and pour contents of the Powr-Tank into a
suitable container.
HOSE ATTACHMENT INSTRUCTIONS (5)
The hose and swivel connector are pre-assembled at the factory.
To attach the swivel connector to the intake fitting of the canister:
1. Push the grooved cuff straight into the intake fitting.
2. To remove, press the release button on top of the intake fitting while pulling the
grooved cuff out.
MAINTENANCE (1-3)
The cloth filter should be cleaned each time you empty the canister. To clean cloth filter,
simply shake off loose particles and brush exposed surface with a soft bristle brush.
The cloth filter may be washed with a heavily diluted detergent in luke warm water. Dry
completely before placing filter back in tank. The wet/dry vacuum should not be stored
with any liquid inside the canister. Always empty liquid from the canister. Before storage
or converting to dry pick-up, run the emptied cleaner for approximately five (5) minutes
to eliminate moisture in the canister, hose, and attachments. Then unclamp the motor
head and set on the edge of the tank to allow evaporation in the tank and power head.
C
CA
AU
UT
TIIO
ON
N::
Excessive foam must be
reduced with a chemical
defoamer sprayed or poured
into a tank. Powr-Defoamer,
part number K2 is recom-
mended. The operator must
turn the motor off when the air
flow is stopped
1
2
3
4
5
