Winding/Installing the Bobbin
20
f
Pass the thread under the hook on the bobbin winding
thread guide, and then wind it counterclockwise under
the pretension disk.
1
Bobbin winding thread guide
2
Pretension disk
3
Pull it in as far as possible
g
Wind the thread clockwise around the bobbin 5 or 6
times, pass the thread through the guide slit in the
bobbin winder seat, and then pull the thread to cut it.
1
Guide slit in bobbin winder seat
(with built-in cutter)
h
Turn on the machine.
• The “Start/Stop” button lights up in orange.
i
Press the “Start/Stop” button to start winding the
bobbin.
j
When the bobbin winding becomes slow, press the
“Start/Stop” button to stop the machine.
k
Cut the thread, slide the bobbin winder shaft to the left
until it snaps into place, and then remove the bobbin.
l
Remove the spool for the bobbin thread from the spool
pin.
Note
• Make sure that the thread is passed under the
pretension disk.
Note
• Be sure to wind the thread clockwise around the
bobbin, otherwise the thread will become wrapped
around the bobbin winder shaft.
CAUTION
• Be sure to cut the thread as described. If the
bobbin is wound without cutting the thread
using the cutter built into the guide slit in the
bobbin winder seat, the thread may become
tangled in the bobbin or the needle may bend
or break when the bobbin thread starts to run
out.
1
2
3
a
CAUTION
• When the bobbin winding becomes slow, stop
the machine, otherwise the machine may be
damaged.
