iWorx® LCI3
502-050A, Effective: April 22, 2013
9
© 2013 Taco Electronic Solutions, Inc.
• Depress ‘Save’
Configuring the Email addresses
The following procedure should be used to enter the email addresses into any LCI3 that is desired to send alarm
emails.
Procedure
Determine who should receive the emails and follow the procedure below to enter the addresses into the LCI3.
• Sign-on to the LCI3
• Select ‘Utilities’ from the Home screen
• Select ‘Network Setup’ from the Utilities screen
• Select ‘Email Addresses’ from the Network Setup screen
• The ‘From’ field needs to contain the email address that is associated with the Username and Password that
the LCI3 uses to gain access with the ISP.
• Enter the email address for the Recipient
• Optional; Enter the email address for the CC Recipient
• Optional; Enter the email address for the Bcc Recipient
• Depress ‘Save’
Configuring selected alarms to be emailed
The following procedure should be used to select the alarms that will be emailed. Most often the alarms that are
selected are critical in nature and require immediate attention. Some examples of critical alarms are; Fan Failure,
Mixed Low limit (freeze condition), Smoke detection and Communication failures to name a few.
NOTE:
All alarms are enabled by default. Alarms need not be disabled if controllers are not installed that
support the alarm.
Procedure
1.Determine which alarms you would like to have annunciated to the email addresses previously entered.
• Sign-on to the LCI3
• Select ‘Utilities’ from the Home screen
• Select ‘Network Setup’ from the Utilities screen
• Select ‘Alarms to Email’ from the Network Setup screen
• Once in the ‘Alarm Email Setup’ screen use the ‘Next, Prev, Top and Bottom’ buttons to navigate to all avail-
able alarms
• All alarms are enabled by default
• Click on the alarm to disable it from being emailed
SELECTING CONTROLLERS
To enter the correct settings for a controller, it must first be part of your control network. When you press the
Con-
troller
button, all of the properly-commissioned controllers on your network will be shown.
If the controllers appear when you press
Controller
, proceed to the next section, ”Adjusting Controllers”.
If no controllers appear when you press
Controller
, then you must introduce the controllers onto the network.
To place a controller on the network:
