iWorx® LCI3
10
502-050A, Effective: April 22, 2013
© 2013 Taco Electronic Solutions, Inc.
1.A service switch is located on the top left side of each controller. To access the switch, a small non-conductive
object may be used to momentarily close the switch by inserting it into the slot of the enclosure. Alternatively, the
switch may be accessed by removing the cover. After the switch is pressed, the LCI3 beeps once to indicate a
new controller has successfully been added to the network. It may be now viewed at the LCI3's controller screen.
2.Repeat this process for every controller on the system.
You now see every controller on your network when you press
Controllers
on the Local Control Interface.
ADJUSTING CONTROLLERS
You can configure any controller on the network from the Local Control Interface. Keep in mind that controllers may
also be renamed and may actually describe the equipment being controlled. For example: Second Floor, First Floor,
Kitchen, and so on.
To program a controller from the Local Control Interface:
1.Press the
Controller
key. The Local Control Interface displays a list of the controllers on the network, as
shown below. If there are more controllers than can be displayed on one screen, click
Next
at the bottom of the
display to show more controllers.
Press anywhere on
any row to choose
that controller.
