●
●
●
Fitting drill bits and accessories
WARNING
ALWAYS remove the Battery from the drill before attaching, adjusting or removing
accessories.
WARNING
DO NOT attempt to tighten drill bits (or any other accessory) by gripping the front
part of the chuck and switching the tool on. This can lead to personal injury and can
cause damage to the chuck
WARNING
NEVER fit any accessory or bit with a maximum speed lower than the no load speed
of he power tool.
1.
2.
3.
4.
- 11 -
Remove the Battery once charging is complete to maximise charge cycles of the
battery and not waste power.
Batteries can become faulty over time, individual cells in the battery can fail and
the battery could short. The charger will not charge faulty batteries. Use another
battery, if possible, to check correct functionality of the charger and purchase a
replacement battery if a faulty battery is indicated.
DO NOT store lithium-ion battery packs in a discharged state over a long period
as this can damage the lithium-ion cells. For long-term storage, store batteries in
a high charge state disconnected from the power tool.
The capacity of batteries will reduce over time. After 100 charge cycles, the
battery’s operation time and the maximum torque performance of the driver will
slightly reduce. This decline will continue until the battery has minimal capacity
after 500 charge cycles. This is normal and not a fault with the battery pack.
Open the Chuck Jaws (1) by rotating the Chuck Collar (2) anti-clockwise.
Place the drill bit or accessory centrally into the chuck.
Tighten the Chuck Jaws by rotating the Chuck Collar clockwise.
When the drill bit or accessory is securely fastened, carefully run the machine to
test that it is running centrally, smoothly and evenly. If the bit is 'wobbling' or not
running centrally, release the chuck, check the accessory for damage, correct its
position, retighten and test again.
