TA Instruments RSA-G2, Manual

Page: 77 / 127

RSA-G2 Getting Started Guide Page 47
Connecting the Test Station Power Cable
CAUTION: Before plugging the power cable into the wall outlet, make sure the instrument is com -
patible with the line voltage. Check the label on the back of the unit to verify the voltage.
MISE EN GARDE: Avant de brancher le câble d'alimentation dans la prise murale, assurez-vous
que l'instrument est compatible avec la tension de la ligne. Consultez l'étiquette au dos de l'appareil
pour vérifier la tension.
Once all cables and lines have been connected to the modular power supplies and the RSA-G2 test station,
you can connect the power cable.
Install the power cable as follows:
1 Make sure the power switch on the lower power supply module is in the Off (O) position.
2 Plug the large, multi-pin cable from the lower power supply to the appropriate connection on the rear
of the RSA-G2 test station, as shown in Figure 29 .
3 Connect the grounding wire to the cabinet as shown in Figure 29 .
4 Plug the power cord from the lower power supply module into the wall outlet.
Figure 29 Power connection on the rear of the RSA-G2 test station.
Grounding wire
Power connection
from lower power
supply