4. Press the
grey ON/OFF button
once. You just activated the trigger in
Manual
ON mode
. Here you can set sensitivity and check that the sound trigger fires
your camera.
5. After testing the camera / cord / trigger, press the grey
ON/OFF button
again,
and you turn the trigger off of the
Manual Mode
. Check that the
Light Bulb
in
the LCD screen shows it with a circle with the slash through it.
6.
Press the
“MOD” (MODE)
button once and
“AUTO”
will appear. This is the
mode which tells the timer to run the program times you set.
THIS IS THE
MODE YOU HAVE TO SET THE TIMER TO AFTER YOU SET UP
YOUR CAMERA REMOTE and MANUALLY TESTED THE SYSTEM.
************ALWAYS CHECK THE LCD SCREEN BEFORE LEAVING
YOUR REMOTE LOCATION*************
7. If you don’t have the
AUTO
Mode activated, your sound trigger will not turn on
at the times you set!
8. There are other
MD “MODES
” you will never use. To see them, keep pressing
MD
to scroll through them. The first of course you use is
AUTO
, press again is
ON
, press again is
RANDOM
(timer picks a random on/off time). The timers
used in these triggers were originally for home lighting use. Press
MD
again and
the timer starts a
COUNTDOWN
from
75 minutes
. Press again, and the Timers
Mod
e is back to
OFF.
9. You do not need to remove the battery after each use,
however,
if you pack your
timers tightly for traveling there is the chance the buttons could get pressed on
and drain the battery. We recommend removing the 9V battery after each use and
check its voltage level before using again.
SENSITIVITY ADJUSTMENT
