2
•
Never transport and/or hang up the devices on the power cord.
•
Ensure that the voltage specified on the type plate of the device agrees with the mains voltage.
•
Prior to connecting the device to the mains supply, ensure that the mains cable and the device are not
damaged in any way.
•
The mains cable of the device must form a loop that points downward (DRIP LOOP) to prevent water
from running along the cable and into the socket outlet.
•
The device must have a residual current circuit breaker (RCCB) with a rated residual current of max. 30
mA connected on the line side. Consult a qualified electrician.
•
Do not bury the mains cable in the ground; follow the installation instructions specified in the applicable
local regulations. Consult a qualified electrician.
•
Prior to placing the device in service, ensure that the installation has been properly executed.
•
Do not use or store the device in areas where there is danger of freezing. In winter the device should be
removed, emptied and stored where it is protected against freezing.
•
The temperature of the pumped liquid must not exceed 35°C (max.) and must not under range 5°C.
•
Avoid using the devices with caustic and corrosive liquids.
•
Devices with obvious damage must not be operated.
Attention!
Use in garden ponds and the protected area of garden ponds is only permitted if the installation
complies with the valid regulations. Consult a qualified electrician.
DO NOT use the pump in or on swimming pools!
1.2.
Pond pump with UVC clarifier
•
Attention!
If there is a defect, the complete pump with UVC unit must be replaced.
•
Warning!
Unintentional use of the device or damage to the housing can result in the emission of
dangerous UV-C radiation. UV-C radiation can cause damage to the eyes and skin even in small doses.
Never look directly into the UV-C tube when it is switched on.
•
Warning!
Do not operate the UV-C emitter when it is removed from the appliance enclosure.
•
Attention!
This device consists partially of glass! Handle with care!
•
Do not let the device run dry (without water flow).
•
Attention!
Temporarily stop using the unit when treating the water and/or fish with additives / care
products.
•
Install the connection socket in the water-protected area and at least 2 m away from the edge of the
pond.
•
Do not operate the pump if there are people in the water (disconnect the pump from the mains supply
beforehand!)
•
Important!
If there is damage to the mains cables or the motor housing the complete pump is unusable
and must be disposed of. Repair is not possible because the connecting cable is permanently cast in the
motor housing.
•
This pump is equipped with a permanent magnet, whose magnetic fields could influence pacemakers,
interfere with electrical/electronic components and wipe data carriers.
•
People with pacemakers should always maintain a safety distance of at least 30 cm from the pump.
2. Scope of delivery
Pump incl. UVC clarifier, connectors, water feature accessories, operating instructions.
Check the device for transport damage and complete delivery. If there is damage the retailer must be notified
without delay, at the latest however, within 8 days of the purchase date.
3. Technical data
Model
TFU 2000 UV 9
Voltage/frequency of pump with UVC clarifier
220 - 240 V~ / 50 Hz
Power consumption of pump with UVC clarifier
45 W
Pump flow rate (Q
max
)
1)
2,000 l/h
Max. delivery head
2 m
Max. immersion depth
2 m
9
